Table of Contents
Advertisement
3
4
A.5 LAN Interface
I cannot access the ADSL Router from the LAN or ping any computer on the LAN.
Steps
1
Check the Ethernet LEDs on the front panel. A LAN LED should be
on if the port is connected to a computer or hub. If the 10M/100M
LEDs on the front panel are both off, refer to Section A.1.2.
2
Make sure that the IP address and the subnet mask of the ADSL
Router and your computer(s) are on the same subnet.
A.6 WAN Interface
Initialization of the ADSL connection failed.
Steps
1
Check the cable connections between the ADSL port and the wall
jack. The DSL LED on the front panel of the ADSL Router should be
on.
2
Check that your VPI, VCI, type of encapsulation and type of
multiplexing settings are the same as what you collected from your
telephone company and ISP.
3
Restart the ADSL Router. If you still have problems, you may need
to verify your VPI, VCI, type of encapsulation and type of
multiplexing settings with the telephone company and ISP.
I cannot get a WAN IP address from the ISP.
Steps
1
The ISP provides the WAN IP address after authenticating you.
section for uploading a configuration file via console port.
The default username is "admin". The default password is "atlantis".
The Password and Username fields are case-sensitive. Make sure
that you enter the correct password and username using the proper
casing.
It is highly recommended to change the default username and
password. Make sure you store the username and password in a
save place.
Corrective Action
Corrective Action
Corrective Action
124
Advertisement
Table of Contents
