Actron CP9580 Instruction Manual page 82

Diagnostic Menu
The following O2 Sensor Tests are available:
1) Rich-to-lean sensor threshold voltage
2) Lean-to-rich sensor threshold voltage
3) Low sensor voltage for switch time
4) High sensor voltage for switch time
5) Rich-to-lean sensor switch time
6) Lean-to-rich sensor switch time
7) Minimum sensor voltage test cycle
8) Maximum sensor voltage test cycle
9) Time between sensor transitions
10) Sensor period
11) Manufacturer specific tests
From the Diagnostic Menu:
1. Select O2 Monitor Tests.
•Use
4 4
arrow key until O2 Monitor
Tests is highlighted.
•Press
2. Select O2 Sensor.
•Use
arrow key until desired O2
Sensor is highlighted.
•Press
✓
The O2 sensors located
upstream (before catalyst) may perform differently than ones located
downstream (after catalyst).
4 – 30 • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
UP or DOWN
ENTER.
UP or DOWN
ENTER.
Diagnostic Menu
=====================
View Fre eze Data
Drive Cycle Monitor
O2 Monitor Tests O2 Monitor Tests
Diag Monitor Tests
On-Board Systems
Vehicle Information
Select O2 Sensor
=====================
O2 Bank1 Sensor1 O2 Bank1 Sensor1
O2 Bank1 Sensor2
O2 Bank2 Sensor1
O2 Bank2 Sensor2