Diagnostic Menu - Actron CP9580 Instruction Manual

Autoscanner plus
Table of Contents

Advertisement

Section 4 – Diagnostic Menu
The first time the scan tool links to the vehicle, the communication
protocol is automatically detected, and is used until the Scan Tool is
turned off or another vehicle is diagnosed.
If an Error Message displays, make sure the OBDII connector is
attached, and the ignition key is on. Cycle ignition key to off for 10
seconds, then on. This may be required to reset computer. If required,
select yes to try again. If problem still exists, refer to "Error
Messages" on page 5-1 of Troubleshooting.
The Scan Tool keeps all data received from the last vehicle
selected until any of the following occurs:
A new vehicle is selected.
Scan Tool is flash programmed to update software.
On initial link to vehicle, Scan Tool checks the status of I/M Monitors
no matter which function is selected.
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • 4 – 1
4

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Auto scanner plus cp9580

Table of Contents