Replacing An Lcc Module; Removing A Copper Cable From An Lcc; Removing An Lcc - EMC CLARiiON DAE2P Hardware Reference Manual

Replacing an LCC module

!

Removing an LCC

Figure 3-11
CAUTION
Handle an LCC gently and use an ESD wristband. Do not remove a
faulty LCC until you have a replacement module available.
LCC modules for DAE2P and DAE3P enclosures are not interchangeable.
Make sure you have the correct replacement part before removing the LCC.
A DAE2P or DAE3P must have at least one LCC installed while it is powered
up. Do not remove both LCCs while the disk enclosure is powered up.
1. Gently press the connector latches to release them as you remove
the copper cables connected to the LCC, as shown in
Note where the cable(s) connect to the LCC; you will need to reconnect
them to the replacement LCC.
P R
R I
PRI
Connector

Removing a copper cable from an LCC

2. Turn the captive screws counterclockwise to release the module,
and then remove the LCC from its slot, as shown in
B
A
E X
P
I
P R
P I
X
E
#
R I
P
P
Replacing an LCC module
Servicing a DAE2P/DAE3P
Figure 3-11.
P R
I #
E X
R I P
P
P X
E
EMC3212
Figure 3-12.
3-17