Connecting The Dae2P/Dae3P To The Back End Bus; Connecting A Disk Enclosure To Another Fc Device - EMC CLARiiON DAE2P Hardware Reference Manual

Installing a DAE2P/DAE3P

Connecting the DAE2P/DAE3P to the back end bus

Figure 2-5
2-12
DAE2P/DAE3P Hardware Reference
Attach your DAE2P/DAE3P to a back end bus after you have set the
enclosure address.
1. Attach the copper cable from the external device (storage
processor, DAE2, or another DAE2P/DAE3P) to the PRI
connector as shown in
another DAE2P/DAE3P, attach a cable from the EXP connector to
the PRI connector in the next DAE2P/DAE3P.
Use HSSDC-HSSDC2 cables to connect a CX-series DPE2 , DAE2, or SPE;
use HSSDC2-HSSDC2 cables to connect DAE2Ps and DAE3Ps, and use
SFP-HSSDC2 cables to connect to a CX3-series SPE.
CAUTION
!
Make sure to orient the HSSDC2 connectors as shown in
The connector thumb clip faces up when connecting to LCC B, and
down when connecting to LCC A. An audible/tangible click
indicates that the cable is completely seated in the LCC connector.
Thumb Clip Up
To Previous Enclosure
Thumb Clip Down
To Previous Enclosure

Connecting a disk enclosure to another FC device

2. If you are installing multiple disk enclosures, cable them as
shown in Figures 2-6
Figure 2-5. If you are continuing the bus to
P R
I
R I
P
PRI
Connector
B
A
E X
P
P R
I
P X
E
#
R I
P
P R
I
R I
P
PRI
Connector
and Figure 2-7.
Figure 2-5.
P R
I
#
E X
P
R I
P
P
X E
EMC3244