C (Card Add) Command; C (Card Delete) Command - Honeywell NETAXS NX4L1 Installation Manual

NetAXS™ Standalone Operation
Standalone Commands
A.3.4 C (Card Add) Command
_C=pn_code_time zone_dev<CR>
Variables:
pn = panel number (1-31)
code = card number (range depends on card format)
time zone = time zone number the card will follow (1-255)
dev = device numbers card will work with, see below:
Example #1:
_C=6_12345_10_1_2_3_4<CR>
This command would configure panel 6 to add a card entry of 12345 to the panels
database, that will be valid on reader 1, 2, 3, and 4 during the times and days specified
by time zone 10.
Example #2
_C=18_52989_120_1_3<CR>
This command would configure panel 18 to add a card entry of 52989 to the panels
database, that will be valid on reader 1 and 3 during the times and days specified by
time zone 120.
A.3.5 C (Card Delete) Command
_C=pn_code<CR>
Variables:
pn = panel number (1-31)
code = card number (range depends on card format)
Example #1:
_C=6_12345<CR>
This command would remove card 12345 from panel 6.
Example #2
_C=18_52989<CR>
This command would remove card 52989 from panel 18.
62 www.honeywell.com
1 = card reader #1
2 = card reader #2
3 = card reader #3
4 = card reader #4