Underwriters Laboratories Incorporated - Honeywell NETAXS NX4L1 Installation Manual

NetAXS™ NX4L1 Installation
Notices

1.6 Underwriters Laboratories Incorporated

The NetAXS™ panel was reviewed by Underwriters Laboratories Incorporated for
Access Control System Units - Category ALVY, UL294 standard. The NetAXS™
panel was reviewed as a stand alone system. The input points only monitor the door
position. The NetAXS™ panel is not intended as a Proprietary Alarm Unit - Category
APOU, UL1076 standard.
The NetAXS™ panel was reviewed using the following Honeywell readers:
OmniAssure (TM) OT30, OmniClass (TM) OM40 and OM55, and OmniProx (TM)
OP30 and OP40.
Notes:
• All field wiring, except for the AC power input and the battery backup/charger
• Communication between panels other than the NetAXS panel has not been
• Underwriters Laboratories (UL) has reviewed only the configurations shown
• UL has not evaluated the compatibility of downstream I/O devices (see
4 www.honeywell.com
wiring, is Class 2 power-limited.
evaluated by UL.
in Section 5.1, "RS-485 Connection via
"RS-485 Connection via
Connection" on page 35 of this guide. Because UL has reviewed the NetAXS
panel only as a standalone system, the computer terminal, NetAXS gateway
panel, and N-485_PCI-2 adapter appear in these sections only to illustrate the
installation and programming of the NetAXS panel.
Section 4.10, "Downstream
PCI-2" on page 31,
NetAXS™" on page 32, and
I/O" on page 28) with the NetAXS panel.
Section 5.2,
Section 5.4, "RS-232