Trouble-Shooting Answer To Question; Troubleshooting - Haier HWM70-918NZP User Manual

Trouble-shooting Answer to question

(If there's breakdown, please pull off the power plug before checking)
The following phenomenon are not breakdowns sometimes. Please confirm again before sending it to
repair.
If there are real breakdowns, please come to the special maintenance department or after-sale
service department of our company. Do not repair it by yourself.
Phenomena
The digitron displays E0.
The drainage cannot
work, or is too slow. The
digitron displays E1.
It stops running in
midway. The digitron
displays E2.
The safety switch acts,
and the spinning cannot
work. The digitron
displays E3.
The water filling does
not work, or is slow, the
digitron displays E4.
The digitron displays E6.
The Not wash
machine
does not
act
Not spin
There is abnormal sound
inside the machine
The water tap leaks
The reason
The top lid is open during
reserve procedure.
Is the drain hose put down?
Is the drain hose blocked?
The top lid is not closed.
Are the laundries put slantingly?
Is the machine slanting?
Is the water tap opened, or is
there water supply failure?
Is the water inlet valve blocked?
Is the water pressure too low?
The water level sensor is bad.
Is there power failure?
Is the power plug inserted tightly?
Is the water level reached preset
position?
Is the power plug inserted tightly?
Is the top lid closed reliably?
Are the laundries set flat?
Is the machine slanting?
Are the laundries put slantingly in
spinning?
Are there any foreign materials?
Is the screw of the jointer of water
inlet hose loose or awry?
How to settle
Close the top lid.

Put down the drain hose. Open and

close the top lid once.
Clean the foreign material. Open and

close the top lid once.
Close the top lid.

Reorder the laundries. Close the top lid.

Place the machine horizontally, open

and close the top lid once.
Open the water tap. Open and close the

top lid once.
Clean the water inlet valve then open

and close the top lid once.
Use after the water pressure is normal.

Please contact the after-sales service

department.
Please use it when there's power

supply.
Insert the power plug tightly.

Fill water to the preset position.

Insert the power plug tightly.

Close the top lid.

Set the laundries flat.

Adjust the machine to be even

Reorder the laundries and close the top

lid.
Remove the foreign materials.

Fasten the screw of the jointer properly.

15