Trouble-Shooting Answer To Question; Troubleshooting - Haier HWM60-Z918 User Manual

Fully automatic washing machine
Hide thumbs


Trouble-shooting Answer to question

(If there's breakdown, please pull off the power plug before checking)
The following phenomena are not breakdowns sometimes. Please confirm again before sending it to
If there are real breakdowns, please come to the special maintenance department or after-sale
service department of our company. Do not repair it by yourself.
The digitron displays E0.
The drainage cannot
work, or is too slow. The
digitron displays E1.
It stops running in
midway. The digitron
displays E2.
The safety switch acts,
and the spinning cannot
work. The digitron
displays E3.
The water filling does
not work, or is slow, the
digital displays E4.
The digitron displays E6.
Not wash
does not
Not spin
There's abnormal sound
inside the machine
The water tap leaks
The reason
●The top lid is opened during
reserve procedure.
●Is the drain hose blocked?
●Is the drain hose put down?
●The top lid is not closed.
●Are the laundries put slantingly?
●Is the machine slanting?
●Is the water tap opened, or is
there water supply failure?
●Is the water inlet valve blocked?
●Is the water pressure too low?
●The water level sensor is bad.
●Is there power failure?
●Is the power plug inserted tightly?
●Is the water level reached preset
●Is the power plug inserted tightly?
●Is the top lid closed reliably?
●Are the laundries set flat?
●Is the machine slanting?
●Are the laundries put slantingly in
●Are there any foreign materials?
●Is the jointer of water inlet hose
loose or awry?
How to settle
Close the top lid.
Clean the foreign material. Open and
close The top Lid Once.
► Put down the drain hose. Open and
close the top lid once.
Close the top lid.
Reorder the laundries. Close the top lid.
The machine will start running after 10
seconds of being placed horizontally.
Open the water tap. Push the start/
Pause button once.
Clean the water inlet valve then push
the start/Pause button once.
Use after the water pressure is normal.
Please contact the after-sales service
Please use it when there's power
Insert the power plug tightly.
Fill water to the preset position.
Insert the power plug tightly.
Close the top lid.
Set the laundries flat.
Adjust the machine to be even.
► Reorder the laundries and close the
top lid.
Remove the foreign materials.
Fasten the jointer properly.

Hide quick links:



  Related Manuals for Haier HWM60-Z918