Installation And Adjustment - Haier HWM70-918NZP User Manual

Installation and adjustment

Please install and adjust the machine according to the requirement of the manual. It is very important
to your security and correct operating the machine.
1. Move the control handle of trundle to
the point 1 and the control handle fix on
the second reference column; Then insert
the base panel from the side and fix it in
the suitable site which aim to the hool of bolt.
The control handle of trundle
The second
reference colunm
Bottom plate
The washing machine away from wall should be overrun 20mm. The largest allowable slope
of the shank base of the machine is 2°. The slanting or rough ground will result in unstable
running or stoppage of the machine. Please adjust it with following methods:
Confirm it's horizontal:

Hang the lead line to check if it is horizontal.
Adjust the adjustable foot:

1. To twist the adjustable foot, please fi rst lift up the side of the leg slightly, loosen the
adjustable nut, and twist the foot. Please make sure to keep the washing machine
in balance.
2. After adjustment, fasten the nut.
The frist reference colunm
Pullback spring
The operation of trundle
Carpet
Figure 1
2.Caste hit the control handle position
shown in the figure ,the control handle
will be fixed by the frist reference
columns to install the screw into the
bottom of the washing machine with
a screwdriver,then gently propped.
Screw
Figure 2
The adjustable foot
Adjustable foot
Front
Back
Carpet
5