How To Change The Direction Of The Drain Hose - Haier HWM70-918NZP User Manual

Fully automatic washing machine
Table of Contents

Advertisement

How to change the direction of the drain hose

1. Dismount the back cover of the
washing machine.
2. Put down the drain hose. Take off
the drain hose hook. Then take off the
screws of the drain hose rack.
Put the drain hose into the cabinet.
(As indicated in Figure 2).
Back cover
Screws
The drain hose shall drain smoothly.
1
The height of the drain hose shall be less
than 10cm , or the drainage will not be smooth,
and cost such long time that the machine may
stop at mid way.
3
If the drain hose is too long, cut it at mid
point. To make smooth drainage,cut the front
end of the hose slantingly.
If the extra hose is too long,cut it either at A or at B point.
5
8
Figure 1
Drain hose rack
3. Extend the drain hose from the other
side, then fix the screw of the drain hose
rack, fix the drain hose hook and hang
the drain hose on the cabinet.
(As indicatedin Figure 3).
4. Install the back cover, first put the
down claws on the cabinet, and then
put the claws(marked with
cabinet from down to up, and fix the
screws. (As indicated in Figure 4)
Figure 2
2
Do not trample or press the drain hose.
If extra drain hose is needed,please
4
make separate purchase.The inner
diameter of the extra hose shall not
less than 30mm, and the length shall
not exceed 1.5m.
)into the
Figure 3
Up claws
Screws
Two sides claws
Down claws
Figure 4

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents