Separating The Inner And Outer Rails - IBM SAN40B-4 - System Storage Switch User & Service Manual

2. Separate the inner and outer slides.
Figure 5. Separating the inner and outer rails
3. Install the inner (smaller) slide on the switch chassis, as Figure 4 on page 10
Table 3. Parts supplied with the rack-mount kit
Item
1
2
3
4
5
6
7
8
9
10
11
12
a. Open one of the slides until the lock engages.
b. Press the lock release lever ( 1 in Figure 5) and remove the inner rail from
the outer rail.
1
c. Repeat step 2a and step 2b for the other rail.
Note: For racks with flush-mount doors, such as the 9306 Netfinity
not install the front brackets. Instead, use the rack-mount slides by
attaching the switch to the set of mounting holes, which are offset 3
inches into the rack.
shows.
Attention: If you use screws longer than 3/16 in., you can damage the switch.
Description
Rack mount slide (inner and outer slide)
Right rack mount bracket (optional bracket for
front of switch)
Left rack mount bracket (optional bracket for
front of switch)
Rack mounting bracket (3-hole)
Nut clip, M5
Screw, 8-32 x 3/16 in., zinc
Screw, M5 x 12
Bracket to slide rack kit (contains items 9 -
12)
Screw, 8-32 x 3/8 in., zinc
Washer, flat, No. 8
Washer, lock, No. 8
Nut, hex, 8-32
SJ000046
Chapter 2. Installing and configuring the switch
Quantity
2
1
1
4
11
11
11
1
5
5
5
5
®
racks, do
11