Recommendations For Cable Management; Inserting Slides Into The Rack Rails - IBM SAN24B-4 Installation, Service And User Manual

Figure 7. Inserting slides into the rack rails
8. Optional step: If the right and left rack mount brackets are installed on the
9. Continue with initial setup of the switch by following the procedures in

Recommendations for cable management

Attention: The minimum bend radius for a 50 micron cable is 51 mm (2 in.)
under full tensile load and 30.5 mm (1.2 in.) with no tensile load.
b. Check the alignment of the slides by sliding the switch in and out of the
rack. Any difficulty moving the switch indicates lateral stress or
misalignment. If this situation occurs, adjust the slide positions until the
movement is smooth.
front corners of the switch, attach both brackets to the cabinet rack by using M5
x 12 screws 7 . See step 4 on page 13 and Figure 3 on page 11. The screws
should pass through the front of each bracket and the slide rail.
Note: Some rack mount kits might use 10-32 nut clips in place of the M5 nut
clips for the locking ears.
"Configuring the switch" on page 16.
DANGER
An electrical outlet that is not correctly wired could place
hazardous voltage on metal parts of the system or the devices that
attach to the system. It is the responsibility of the customer to
ensure that the outlet is correctly wired and grounded to prevent
an electrical shock. (D004)
Note: Do not connect the switch to the network until you perform one of the
following steps:
v Set the internet protocol (IP) address.
v Verify that the default IP address does not conflict with the existing IP
addresses in the same network.
SJ000049
Chapter 2. Installing and configuring the switch
15