The Switch supports 802.1d STP and 802.1w Rapid STP. The spanning tree commands in the Command Line Interface (CLI)
are listed (along with the appropriate parameters) in the following table.
Command
config stp
config stp ports
enable stp
disable stp
show stp
show stp ports
Each command is listed, in detail, in the following sections.
DES-3000 Series Layer 2 Switch CLI Reference Manual
Parameters
{maxage <value 6-40> | hellotime <value 1-10> | forwarddelay
<value 4-30> | priority <value 0-61440> | version [rstp | stp] |
txholdcount <value 1-10> | fbpdu [enabled | disabled] | lbd [enabled
| disabled] | lbd_recover_timer [0 | <sec 60-1000000]}
<portlist> {cost [auto | <value 1-200000000>] | priority <value 0-
240> | migrate [yes | no] | edge [true | false] | p2p [true | false |
auto] | state [enabled | disabled] | lbd [enabled | disabled] |
fbpdu [enabled | disabled] }
{<portlist>}
S
PANNING
74
10
T
C
REE
OMMANDS