Login; Logout; Ping - D-Link DES-3026 - Switch Reference Manual

login

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To initiate the login procedure:

logout

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To terminate the current user's console session:

ping

Purpose
Syntax
Description
Parameters
DES-3000 Series Layer 2 Switch CLI Reference Manual
Used to log in a user to the Switch's console.
login
This command is used to initiate the login procedure. The user will be
prompted for his Username and Password.
None.
None.
DES-3026:4#login
Command: login
UserName:
Used to log out a user from the Switch's console.
logout
This command terminates the current user's session on the Switch's
console.
None.
None.
DES-3026:4#logout
Used to test the connectivity between network devices.
ping <ipaddr> {times <value 1-255>} {timeout <sec 1-99>}
The ping command sends Internet Control Message Protocol
(ICMP) echo messages to a remote IP address. The remote IP
address will then "echo" or return the message. This is used to
confirm connectivity between the Switch and the remote device.
<ipaddr> - Specifies the IP address of the host.
times <value 1-255> - The number of individual ICMP echo
messages to be sent. The maximum value is 255. The default is
0.
timeout <sec 1-99> - Defines the time-out period while waiting for
a response from the remote device. A value of 1 to 99 seconds
can be specified. The default is 1 second.
21