The network monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
show packet ports
show error ports
show utilization
clear counters
clear log
show log
enable syslog
disable syslog
show syslog
create syslog host
config syslog
delete syslog host
show syslog host
config log_save_timing
show log_save_timing
Each command is listed, in detail, in the following sections.
DES-3000 Series Layer 2 Switch CLI Reference Manual
N
ETWORK
Parameters
<portlist>
<portlist>
[cpu | ports {<portlist>}]
{ports <portlist>}
{index <value_list X-Y>}
<index 1-4> {severity [informational | warning | all] | facility [local0 |
local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number> | ipaddress <ipaddr> state [enable | disable]}
{host [all <index 1-4>]} {severity [informational | warning | all] |
facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 |
local7] | udp_port <udp_port_number> | ipaddress <ipaddr> | state
[enable | disable]}
[<index 1-4> | all]
{<index 1-4>}
[time_interval <min 1-65535> | on_demand | log_trigger]
M
ONITORING
59
9
C
OMMANDS