The switch port commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config ports
show ports
Each command is listed, in detail, in the following sections.
DES-3000 Series Layer 2 Switch CLI Reference Manual
Parameters
config ports [<portlist> | all] {speed [auto | 10_half | 10_full |
100_half | 100_full | {1000_full {[master | slave]}}] | flow_control
[enable | disable] | state [enable | disable] | description [<desc 1-
32> | clear_description]}
{<portlist>} {[description | err_disabled]}
S
WITCH
23
5
P
C
ORT
OMMANDS