To Enable Autoconfiguration On The Switch - D-Link DES-3026 - Switch Reference Manual

When autoconfig is enabled and the Switch is rebooted, the normal login screen will appear for a few moments while the
autoconfig request (i.e. download configuration) is initiated. The console will then display the configuration parameters as they
are loaded from the configuration file specified in the DHCP or TFTP server. This is exactly the same as using a download
configuration command. After the entire Switch configuration is loaded, the Switch will automatically "logout" the server. The
configuration settings will be saved automatically and become the active configuration.
Upon booting up the autoconfig process is initiated, the console screen will appear similar to the example below. The
configuration settings will be loaded in normal order.
Example usage:

To enable autoconfiguration on the Switch:

DES-3026:4#enable autoconfig
Command: enable autoconfig
Success.
DES-3026:4#
Copyright(C) 2004-2007 D-Link Corporation. All rights reserved.
UserName:
Password:
DES-3026:4#
DES-3026:4##ROUTE
DES-3026:4#
DES-3026:4#
DES-3026:4#create iproute default 172.18.212.253
Command: create iproute default 172.18.212.253
Success.
DES-3026:4#
DES-3026:4#
The very end of the autoconfig process including the logout appears like this:
DES-3026:4#
DES-3026:4#
DES-3026:4##-------------------------------------------------------------------
DES-3026:4#
DES-3026:4#
DES-3026:4#
DES-3026:4#---------------------------------------------------------------------
DES-3000 Series Layer 2 Switch CLI Reference Manual
DES-3026 Fast Ethernet Switch Command Line Interface
Firmware: Build 2.00.016
End of configuration file for DES-6500
57