Create Link_Aggregation; Delete Link_Aggregation Group_Id; To Create A Link Aggregation Group - D-Link DES-3026 - Switch Reference Manual

create link_aggregation

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:

To create a link aggregation group:

delete link_aggregation group_id

Purpose
Syntax
Description
Parameters
Restrictions
DES-3000 Series Layer 2 Switch CLI Reference Manual
Used to create a link aggregation group on the Switch.
create link_aggregation group_id <value 1-3> {type [lacp | static]}
This command will create a link aggregation group with a unique identifier.
<value 1-3> − Specifies the group ID. The Switch allows up to 3 link
aggregation groups to be configured. The group number identifies each of
the groups. group_id 3 is designed for the uplink modules only (the last two
ports on the Switch (9-10, 17-18, 25-26) and can only be configured for
them.
type – Specify the type of link aggregation used for the group. If the type is
not specified the default type is static.
lacp – This designates the port group as LACP compliant. LACP
allows dynamic adjustment to the aggregated port group. LACP
compliant ports may be further configured (see config lacp_ports).
LACP compliant must be connected to LACP compliant devices.
static – This designates the aggregated port group as static. Static
port groups can not be changed as easily as LACP compliant port
groups since both linked devices must be manually configured if the
configuration of the trunked group is changed. If static link aggregation
is used, be sure that both ends of the connection are properly
configured and that all ports have the same speed/duplex settings.
Only administrator-level users can issue this command.
DES-3026:4#create link_aggregation group_id 1
Command: create link_aggregation group_id 1
Success.
DES-3026:4#
Used to delete a previously configured link aggregation group.
delete link_aggregation group_id <value 1-3>
This command is used to delete a previously configured link aggregation
group.
<value 1-3> − Specifies the group ID. The Switch allows up to 3 link
aggregation groups to be configured. The group number identifies each of
the groups. group_id 3 is designed for the uplink modules only (the last two
ports on the Switch (9-10, 17-18, 25-26) and can only be configured for
them.
Only administrator-level users can issue this command.
123