Levelling; Water Connections; Water Inlet Connection; Water Drain Connection - John Lewis JLBIDW1200 Instruction Manual

Levelling

Good levelling is essential for correct closure
and sealing of the door. When the appliance
is correctly levelled, the door will not catch on

Water connections

Water inlet connection

This appliance must be connected to a cold
water supply.
For making the connection itself, the coupling
nut fitted to the machine's inlet hose is
designed to screw onto a 3/4" gas thread
spout or to a purpose made quick-coupling
tap such as the Press-block.
The water pressure must be within the limits
given in the "Technical data". Your local
Water Authority will advise you on the
average mains pressure in your area.
The water inlet hose must not be kinked,
crushed, or entangled when it is being
connected.
The appliance features inlet and drain hoses
which can be turned either to the left or the
right to suit the installation by means of the
locknut. The locknut must be correctly
fitted to avoid water leaks. (Attention!
NOT all models of dishwashers have inlet and
drain hoses provided with a locknut.)
If the appliance is connected to new pipes or
pipes which have not been used for a long
time, you should run the water for a few
minutes before connecting the inlet hose.
DO NOT use connection hoses which
have previously been used on an old
appliance.
either side of the cabinet. If the door does not
close correctly, loosen or tighten the
adjustable feet until the machine is perfectly
level.
This appliance has been fitted with
safety features which will prevent the
water used in the appliance from
returning back into the drinking water
system. This appliance complies with
the applicable plumbing regulations.

Water drain connection

The end of the drain hose can be connected
in the following ways:
1. To the sink outlet spigot, securing it to the
underside of the work surface. This will
prevent waste water from the sink running
into the machine.
2. To a stand pipe provided with venthole,
minimum internal diameter 4 cm.
max 85 cm
The drain hose can face either to the right or
left of the dishwasher.
27
min 40 cm