Select And Start A Washing Programme - John Lewis JLBIDW1200 Instruction Manual

4. To change the setting, press function
button B again, the digital display shows
the new setting
5. To memorize the operation, switch off the
dishwasher by pressing the On/off
button.
Select and start a washing
programme
Select the washing programme
and delay start with the door
slightly opened. The start of the
programme or the countdown of
the delay start will occur only
after the closure of the door.
Until then it is possible to modify
the settings.
1. Check that the baskets have been loaded
correctly and that the spray arms are free
to rotate.
2. Check that the water tap is opened.
3. Press the On/Off button. The dishwasher
must be in setting mode.
4. Press the button corresponding to the
required programme (see "Washing
programmes" chart). Close the
dishwasher door, the programme starts
automatically.
If you decide to revert back to
the use of individual detergents
we advise that you:
1. Deactivate the Multi tab function.
2. Fill up the salt container and the
rinse aid dispenser again.
3. Adjust the water hardness setting
to the highest setting and perform
1 normal washing programme
without loading any dishes.
4. Adjust the water hardness setting
according to the hardness of the
water in your area.
5. Adjust the rinse aid dosage.
Setting and starting the
programme with delay
start
1. After having selected the washing
programme, press the delay start button
until the number of hours for the delay
start appear in the digital display. The start
of the selected washing programme can
be delayed for between 1 and 19 hours.
2. Close the dishwasher door, the
countdown starts automatically.
3. The countdown will decrease with steps
of 1 hour.
4. The opening of the door will interrupt the
countdown. Close the door; the
countdown will continue from the point at
which it was interrupted.
5. Once the delay start has elapsed the
programme will start automatically.
20