Setting Manually; Setting Electronically - John Lewis JLBIDW1200 Instruction Manual

Water hardness
Clarke °TH
5 - 12 7 - 18
< 5 < 7
Setting the water
softener
The water softener must be set in two ways:
manually, using the water hardness dial and
electronically.

Setting manually

The dishwasher is factory set at
position 2.
1. Open the dishwasher door.
2. Remove the lower basket from the
dishwasher.
3. Turn the water hardness dial to position 1
or 2 (see table above).
4. Replace the lower basket.

Setting electronically

The dishwasher is factory set at level
5.
1. Press the On/Off button. The dishwasher
must be in setting mode.
Adjusting the water hardness
mmol/l manually
0,7 - 1,8
< 0,7
11
setting
electronically
1 level 2
1 level 1
2. Simultaneously press and hold function
buttons B and C, until the lights of
function buttons A, B and C start flashing.
3. Press function button A, the lights of
function buttons B and C go off while the
light of function button A continues to
flash. The digital display shows the current
level and a sequence of intermittent
audible signals can be heard.
Examples:
displayed, 5 intermittent audible
signals, pause, etc. = level 5
displayed, 10 intermittent audible
signals, pause, etc. = level 10
4. To change the level, press function button
A. Each time the button is pressed the
level changes. (For the selection of the
new level see the chart).
Examples:
If the current level is 5, by pressing
function button A once, level 6 is selected,
if the current level is 10, by pressing
function button A once, level 1 is selected.
5. To memorize the operation, switch off the
dishwasher by pressing the On/Off
button.
Use of salt
yes
no