Multi Tab Function; Activation/Deactivation Of The Rinse Aid Dispenser - John Lewis JLBIDW1200 Instruction Manual

Multi tab function

This appliance is equipped with the Multi tab
function, that allows the use of combi
detergent tablets.
These products are detergents with a
combined cleaning, rinsing and salt functions.
They can also contain other different agents
depending on which kind of tablets you
choose ("3 in 1", "4 in 1", "5 in 1" etc...).
Check whether these detergents are suitable
for your water hardness. See the
manufacturers instructions.
Once this function is selected it will remain
active for all following wash programmes.
With the selection of this function the inflow
of rinse aid and salt from each respective
supply container is automatically deactivated
and also the indicator lights for salt and rinse
aid are deactivated.
When using the Multi tab function, the cycle
duration may change. If this is the case, the
running time for the programme is
automatically updated on the digital display.
Activate/deactivate the Multi tab
function before the start of a washing
programme.
Once the programme is running, the
Multi tab function can NO longer be
changed. If you want to cancel the
Multi tab function you have to cancel
the programme setting and then
deactivate the Multi tab function.
In this case you have to set a washing
programme (and desired options)
again.
Activation/deactivation
of the Multi tab function
Simultaneously press and hold the two
buttons positioned over the word Multi tab,
until the Multi tab indicator light illuminates.
This means that the function is active.
To deactivate the function press the same
buttons again until the Multi tab indicator light
turns off.
If the drying results are not
satisfactory we suggest that you:
1. Fill up the rinse aid dispenser with
rinse aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position
2.
• The activation/deactivation of the
rinse aid dispenser is only possible
with the Multi tab function active.
Activation/deactivation
of the rinse aid dispenser
1. Press the On/Off button. The dishwasher
must be in setting mode.
2. Simultaneously press and hold function
buttons B and C, until the lights of
function buttons A, B and C start flashing.
3. Press function button B, the lights of
function buttons A and C go off while the
light of function button B continues to
flash. The digital display shows the current
setting.
rinse aid dispenser deactivated
rinse aid dispenser activated
19