Advertisement

Quick Links

Dishwasher
JLBIDW917
User Manual

Advertisement

Table of Contents
loading

Summary of Contents for John Lewis JLBIDW917

  • Page 1 Dishwasher JLBIDW917 User Manual...
  • Page 2: Table Of Contents

    Contents The salt container Safety information Filling with rinse aid Children and vulnerable people safety Daily use General Safety Loading cutlery and dishes Safety instructions Using the detergent Installation Setting and starting a programme Electrical connection Hints and tips Water connection General Service Using salt, rinse aid and detergent...
  • Page 3: Safety Information

    Safety information Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
  • Page 4 by clients in hotels, motels, bed & breakfast and other residential – type environments. Do not change the specification of this appliance. • The operating water pressure (minimum and maximum) must be • between 0.5 (0.05) / 8 (0.8) bar (MPa) Follow the maximum number of 9 place settings.
  • Page 5: Safety Instructions

    Safety instructions • Do not pull the mains cable to disconnect the Installation appliance. Always pull the mains plug. • This appliance is fitted with a 13 A mains plug. If Warning! Only a qualified it is necessary to change the mains plug fuse, person must install this use only a 13 A ASTA (BS 1362) fuse (UK and appliance.
  • Page 6: Service

    Service • To repair the appliance contact the Authorised Service Centre. • Use original spare parts only. Disposal Warning! Risk of injury or suffocation. • Disconnect the appliance from the mains supply. • Cut off the mains cable and discard it. •...
  • Page 7: Installation

    Installation Insert the appliance after the adjustment of the Warning! appliance level. When inserting the appliance, • It is dangerous to alter the ensure that the water inlet and drain hoses are specifications or attempt to not kinked or squashed. During all operations modify the appliance in any way.
  • Page 8: Product Description

    Product description 1. Upper spray arm 6. Air vent 2. Lower spray arm 7. Rinse aid dispenser 3. Filters 8. Detergent dispenser 4. Rating plate 9. Upper basket 5. Salt container Beam-on-Floor The Beam-on-Floor is off when the appliance is deactivated. The Beam-on-Floor is a light that is displayed on the floor below the appliance door.
  • Page 9: Control Panel

    Control panel 1. On/off button 4. Programme buttons 2. Display 5. Indicators 3. Delay button Indicators Indicator Description Extra dry Extra dry indicator. Rinse aid Rinse aid indicator. It is always off while the programme operates. Salt Salt indicator. It is always off while the programme operates. Dishwasher User Manual...
  • Page 10: Programmes

    Programmes Programme Degree of soil Programme phases Options Type of load • Normal soil • Prewash • Extra dry 50° Eco • Crockery and cutlery • Wash 50 °C • Rinses • Dry • All • Prewash • Extra dry 45°-70°...
  • Page 11: Information For Test Institutes

    Water Energy Duration Programme (kWh) (min) Rinse hold 1) The pressure and the temperature of the water, the variations of the mains supply, the options and the quantity of dishes can change the values. Information for test institutes To receive the necessary information for conducting performance tests (e.g.
  • Page 12: Settings

    Settings How to enter user mode Programme selection mode Make sure the appliance is in programme and user mode selection mode. When the appliance is in programme selection To enter user mode, press and hold simultaneously mode it is possible to set a programme and to Eco and Auto until the indicators Delay, Eco, Auto and Intensive flash and the display is blank.
  • Page 13: The Rinse Aid Empty Notification

    German degrees French degrees mmol / l Clarke de- Water softener level (°dH) (°fH) grees 37 - 42 65 - 75 6.5 - 7.5 46 - 52 29 - 36 51 - 64 5.1 - 6.4 36 - 45 23 - 28 40 - 50 4.0 - 5.0 28 - 35...
  • Page 14: Acoustic Signals

    Acoustic signals Caution! Do not try to close the appliance door within 2 Acoustic signals sound when a malfunction of minutes after automatic the appliance occurs. It is not possible to opening. This can cause deactivate these acoustic signals. damage to the appliance. There is also an acoustic signal that sounds DryAssist is automatically activated with all when the programme is completed.
  • Page 15: Options

    Options Desired options must be activated Every time 50° Eco is activated, every time before you start a Extra dry is off and needs to be programme. chosen manually. It is not possible to activate or deactivate options while a How to activate Extra dry programme is running.
  • Page 16: Before First Use

    Before first use 1. Make sure that the current level of the water softener agrees with the hardness of the water supply. If not, adjust the level of the water softener. 2. Fill the salt container. 3. Fill the rinse aid dispenser. 4.
  • Page 17: Filling With Rinse Aid

    Filling with rinse aid Caution! Use branded rinse aid for dishwashers only. Never fill the rinse aid dispenser with any other substances (e.g. dishwasher cleaning agent, liquid detergent). This would damage the appliance. Rinse aid ensures thorough rinsing, and spot and streak free drying. Rinse aid is automatically added during the last rinse.
  • Page 18: Daily Use

    Daily use 1. Open the water tap. 2. Press the on/off button to activate the appliance. Make sure that the appliance is in programme selection mode. • If the salt indicator is on, fill the salt container. • If the rinse aid indicator is on, fill the rinse aid dispenser.
  • Page 19 The cutlery basket Warning! Knives with long blades, stored in an upright position, are a potential hazard. Long and/or sharp items of cutlery such as carving knives must be positioned horizontally in the upper basket. Take care when loading or unloading sharp items such as knives.
  • Page 20 Caution! Ensure that the spray arms can rotate freely before you close the appliance door. Adjusting the height of the upper basket Caution! Never lift or lower the basket on one side only. To load very large plates move the upper basket to the higher position.
  • Page 21: Using The Detergent

    24 cm 27 cm Moving back the upper basket to the lower position 1. Pull out the basket until it stops. 2. Carefully lift both sides upwards and then allow the mechanism to drop back down slowly, keeping hold of it. Using the detergent 20 cm 31 cm...
  • Page 22: Setting And Starting A Programme

    Setting and starting a If the door is opened for more than programme 30 seconds during the drying phase, the running programme ends. It does not happen if the The Auto off function door is opened by DryAssist This function decreases energy consumption by function.
  • Page 23: Hints And Tips

    Hints and tips • Do not use more than the correct quantity of General detergent. Refer to the instructions on the detergent packaging. Follow the hints below to ensure optimal cleaning and drying results in daily use and to What to do if you want to stop help you protect the environment.
  • Page 24: Before Starting A Programme

    • Make sure that the spray arm can move freely before you start a programme. Before starting a programme Before you start the selected programme, make sure that: • The filters are clean and correctly installed. • The cap of the salt container is tight. •...
  • Page 25: Care And Cleaning

    Care and cleaning Warning! Before maintenance, deactivate the appliance and disconnect the mains plug from the main socket. Dirty filters and clogged spray arms decrease the washing results. Make 2. Remove the filter (C) out of filter (B). a check regularly and, if necessary, 3.
  • Page 26: Cleaning The Spray Arms

    Internal cleaning • Carefully clean the appliance, including the rubber gasket of the door, with a soft damp cloth. • If you regularly use short duration programmes, these can leave deposits of grease and limescale inside the appliance. To prevent this, we recommend to run long duration programmes at least 2 times per month.
  • Page 27: Troubleshooting

    Troubleshooting If the appliance does not start or it stops during With some problems, the display shows operation. Before you contact an Authorised an alarm code. Service Centre, check if you can solve the The majority of problems that can occur problem by yourself with the help of the can be solved without the need to information in the table.
  • Page 28: The Washing And Drying Results Are Not Satisfactory

    Problem and alarm code Possible cause and solution The appliance stops and starts • It is normal. It provides optimal cleaning results and energy savings. more times during operation. The programme lasts too long. • If the delayed start option is set, cancel the delay setting or wait for the end of the countdown.
  • Page 29 The washing and drying results are not satisfactory Poor drying results. • Tableware has been left for too long inside the closed appliance. • There is no rinse aid or the dosage of rinse aid is not enough. Set the rinse aid dispenser to a higher level. •...
  • Page 30 The washing and drying results are not satisfactory Dull, discoloured or chipped table- • Make sure that only dishwasher-safe items are washed in the appli- ware. ance. • Load and unload the basket carefully. Refer to "Loading cutlery and dishes". •...
  • Page 31: Product Information Sheet

    Product information sheet Trade Mark John Lewis Model JLBIDW917 911076051 Rated capacity (standard place settings) Energy efficiency class Energy consumption in kWh per year, based on 280 standard clean- ing cycles using cold water fill and the consumption of the low power modes.
  • Page 32: Additional Technical Information

    Additional technical information Dimensions Width / height / depth (mm) 446 / 818 - 898 / 550 Voltage (V) 220 - 240 Electrical connection Frequency (Hz) Water supply pressure Min. / max. 0.5 (0.05) / 8 (0.8) bar (MPa) Water supply max 60 °C Cold water or hot water 1) Refer to the rating plate for other values.
  • Page 33: Water Connection

    Water connection • To the sink outlet spigot, securing it to the Water inlet connection underside of the work surface. This will prevent waste water from the sink running into the This appliance may be fed with either hot appliance. (maximum 60 °C) or cold water.
  • Page 34 must be removed. Failure to remove all the membrane will result in food particles building up over time eventually blocking the appliance drain hose spigot. Dishwasher User Manual...
  • Page 35: Electrical Connection

    Electrical connection • If necessary, have the domestic wiring system Warning! The manufacturer socket replaced. In case that the electrical cable accepts no liability for failure has to be replaced, contact your local repair to observe the following agent. safety precautions. •...
  • Page 36: Repairs - After Sales Service

    Shopping is easy with John Lewis Shops manual, the next step is to contact John Lewis John Lewis, Aberdeen 01224 625 000 technical support on: John Lewis, Basingstoke 01256 406200...
  • Page 37 John Lewis, Croydon 020 8662 4730 John Lewis, Stratford 020 8532 3500 John Lewis, Horsham 01403 214 740 John Lewis, The Trafford Centre 0161 491 4040 John Lewis, Ipswich 01473 275 850 John Lewis, Watford 01923 244 266 John Lewis, Newbury 01635 263 980...
  • Page 38 Environmental concerns marked with the symbol with the household Recycle materials with the symbol . Put the waste. Return the product to your local packaging in relevant containers to recycle it. recycling facility or contact your municipal office. Help protect the environment and human health by recycling waste of electrical and electronic appliances.
  • Page 39 Dishwasher User Manual...
  • Page 40 156914424-A-312019 ( Subject to change without notice. )

Table of Contents