Standby Mode Conditions And Descriptions - Acer Extensa 61X Service Manual

ON MODE
Normal full-on operation
STANDBY MODE
The notebook consumes very low power in standby mode. Data remain intact in the system memory until
battery is drained.
The necessary condition for the notebook to enter standby mode is that the reserved disk space size for
saving system and video memory is insufficient so the notebook is unable to enter hibernation mode. In this
situation, there are three ways to enter standby mode:
Press the standby/hibernation hotkey Fn-F7 (
Set a value for the System Standby/Hibernation Timer in Setup. If the waiting time specified by this
timer elapses without any system activity, the notebook goes into standby mode.
Invoked by the operating system power saving modes
The following signals indicate that the notebook is in standby mode:
The buzzer beeps (when you press the standby/hibernation hotkey)
The indicator light flashes
To leave standby mode and return to normal mode, press the any key. If an incoming PCMCIA modem
event occurs and the Modem Ring Wake Up From Standby is enabled, the system returns to normal mode.
Table 1-36

Standby Mode Conditions and Descriptions

Condition
The condition to enter
Standby Mode
The condition of
Standby Mode
The condition back to
On Mode
HIBERNATION MODE
In hibernation mode (also known as zero-volt hibernation-to-disk mode), power shuts off. The notebook
saves all system information onto the hard disk before it enters hibernation mode. Once you turn on the
power, the notebook restores this information and resumes where you left off upon leaving hibernation
mode.
1-32
"Hard Disk Drive" is [Disabled] in System Security of BIOS SETUP.
"Hard Disk 0" is [None] in Basic System Configuration of BIOS SETUP.
HDD has not located enough free contiguous disk space generated by Sleep Manager
and this free space is not corrupted.
Standby/Hibernation Timer times-out or Standby/Hibernation HotKey pressed and
there is no activity within 1/2 second.
Issue a beep.
Flash standby LED with 1 Hz frequency.
Disable the mouse, serial and the parallel port.
The keyboard controller, HDD and VGA enter the standby mode.
Stop the CPU internal clock.
All the functions are disabled except the keyboard, battery low warning and modem
ring wake up from standby (if enabled).
Any one of following activities will let system back to Normal Mode:
Any keystroke (Internal KB or External KB)
Modem ring.
)
Description
Service Guide