Acer Extensa 61X Service Manual page 138

Table 2-14 NS87336VJG Pin Descriptions (continued)
Pin No.
DENSEL 46
(Normal Mode)
DENSEL 76
(PPM Mode)
/DIR 39
(Normal Mode)
/DIR 78
(PPM Mode)
/DR0, 42, 43
/DR1
(Normal Mode)
/DR1 83
(PPM Mode)
/DR23 47
/DRATE0 50, 49
/DRATE1
(Normal Mode)
/DRATE0 85
(PPM Mode)
DRQ0 54
DRQ1 31
DRQ2 2
Major Chips Description
I/O Description
O FDC Density Select. DENSEL indicates that a high FDC density data
rate (500 Kbs, 1 Mbs or 2 Mbs) or a low density data rate (250 or 300
Kbs) is selected. DENSEL is active high for high density (5.25-inch
drives) when IDENT is high, and active low for high density (3.5-inch
drives) when IDENT is low. DENSEL is also programmable via the
Mode command.
O FDC Density Select.
signal in PPM Mode when PNF=0.
O FDC Direction. This output determines the direction of the floppy disk
drive (FDD) head movement (active = step-in; inactive = step-out)
during a seek operation. During reads or writes, DIR is inactive.
O FDC Direction. This pin offers an additional Direction signal in PPM
Mode when PNF = 0.
O FDC Drive Select 0, 1. These are the decoded drive select outputs
that are controlled by Digital Output Register bits D0, D1. The Drive
Select outputs are gated with DOR bits 4-7. These are active low
outputs. They are encoded with information to control four FDDs
when bit 4 of the Function Enable Register (FER) is set.
exchanges logical drive values with DR1 when bit 4 of Function
Control Register is set.
O FDC Drive Select 1. This pin offers an additional Drive Select signal
in PPM Mode when PNF = 0. It is drive select 1 when bit 4 of FCR is
0. It is drive select 0 when bit 4 of FCR is 1. This signal is active
low.
O FDC Drive 2 or 3. /DR23 is asserted when either Drive 2 or Drive 3 is
assessed(except during logical drive exchange).
O FDC Data Rate 0, 1. These outputs reflect the currently selected
FDC data rate (bits 0 and 1 in the Configuration Control Register
(CCR) or the Data Rate Select Register (DSR), whichever was written
to last). The pins are totem-pole buffered outputs (6 mA sink, 6 mA
source).
O FDC Data Rate 0. This pin provides an additional Data Rate signal,
in PPM mode, When PNF=0.
O DMA Request 0, 1, 2.
controller that a data transfer is required. This DMA request can be
sourced by one of the following: FDC or Parallel Port.
When it is not
the sourced device is disabled or when the sourced device is
configured with no DMA, it is also in TRI-STATE. Upon reset, DRQ2
is used by the FDC.
This pin offers an additional Density Select
\An active high output that signals the DMA
sourced by and of them, it is in TRI-STATE. When
DR0
2-81