Replacing Memory; Removing The Memory Door; Installing And Removing Memory - Acer Extensa 61X Service Manual

4.2

Replacing Memory

Follow these steps to insert memory modules:
1. Turn the computer over to access the base.
2. Remove the screw from the memory expansion door and remove the door.
The memory door screw is part of the memory door and does not
separate from the memory door.
Figure 4-4

Removing the Memory Door

3. Remove the memory modules from its shipping container.
4. Align the connector edge of the memory module with the key in the connector. Insert the
edge of the memory module board into the connector. Use a rocking motion to fully insert the
module. Push downward on each side of the memory module until it snaps in place.
To remove the memory module, release the slot locks found on both ends of the memory slot
to release the DIMM. Then pull out the memory module.
Figure 4-5

Installing and Removing Memory

4-6 Service Guide