Table of Contents
Advertisement
44
Setting up the Symantec Mail Security Appliance
How to set up the appliance
Completing setup
3
Select primary and secondary internal IP addresses from the Primary IM IP
address and Secondary IM IP address drop-down lists.
The primary IP address listens for incoming instant messages. The secondary
IP address routes file transfers through the Scanner and must be a different
IP address from the primary IP address.
4
Under External IM Interface, select the Ethernet network that IM clients use
to communicate with public servers from the Ethernet: drop-down list.
The external Ethernet network interface may be the same as the internal
interface.
5
Select the external IP address from the External IP: drop-down list.
If you are using different interface cards for incoming and outgoing traffic,
assign different IP addresses to the primary internal address and the external
address.
The external IP address may be the same as the primary internal IP address.
If you have more than one network, the primary internal IP address and
external IP address are probably going to be different. The primary IP address
would then be dedicated to listening for IM messages and the external IP
address dedicated to outgoing IM.
The Setup Summary panel is displayed.
See
"To review and finalize settings"
To review and finalize settings
1
On the Setup Wizard Summary panel, review the settings shown.
2
If you are satisfied with the settings, click Finish to save them.
If not, click Back to revise your settings, or Cancel to end without saving any
changes. If you cancel, you won't be able to use the appliance until you
complete the setup.
Your appliance is now nearly ready to use, with a set of default policies designed
for most enterprise installations. Review the sections below to determine what
additional setup tasks you need to perform.
Adding more Scanners
Repeat the steps in the section called "Setting up a Scanner" if you are adding
additional Scanners.
on page 44.
Advertisement
Table of Contents
