Table of Contents
Advertisement
40
Setting up the Symantec Mail Security Appliance
How to set up the appliance
Setting up a Scanner
To review and finalize settings
1
On the Setup Wizard Summary panel, review the settings shown.
2
If you are satisfied with the settings, click Finish to save them.
If not, click Back to revise your settings, or Cancel to end without saving any
changes. If you cancel, you won't be able to use the appliance until you
complete the setup.
If you are adding a Scanner on the same appliance as your Control Center, see
Setting up a Control Center with optional
only apply to adding a Scanner on a different appliance than the appliance hosting
your Control Center.
Note: If you plan to use one appliance as both a Control Center and a Scanner, add
the Scanner on that appliance before adding other Scanners.
Add a Scanner
Use the Add Scanner Wizard to set up a Scanner appliance. You run the Add
Scanner Wizard from a Control Center that you previously set up.
Note: None of the settings you specify using the wizard are final until you click
Finish at the end of the wizard. If you step through all the panels of the wizard
and do not click Finish, you will not make any changes to configuration settings.
To configure host IP settings
1
Log into the Control Center.
See
"Logging in and logging out"
2
From the Control Center, click Administration > Hosts > Configuration.
3
If you are adding your first Scanner, you will now see the Add Scanner Wizard.
Otherwise click Add on the Host Configuration page.
4
On the Scanner Host Settings panel, identify your new Scanner by typing a
description and a host name or IP address.
Continue completing the Add Scanner Wizard.
See
"To register the Scanner and specify time settings "
Scanner. The instructions in this section
on page 45.
on page 41.
Advertisement
Table of Contents
