Symantec 10547829 - Mail Security For Smtp 5.0 Smb Installation Manual page 42

42 Setting up the Symantec Mail Security Appliance
How to set up the appliance
If you select both inbound and outbound and you have specified two
physical ports, you will see the Create Optional Virtual IP Address panel
next. Proceed with step 2.
If the above does not apply:
If you chose to filter inbound mail, you will see the Inbound Mail
Filtering panel. Proceed with step 4.
If you chose to filter outbound mail only, you will see the Outbound
Mail Filtering panel.
See "To specify outbound mail filtering settings"
2
On the Create Optional Virtual IP Address panel, read the instructions and
click Yes or No.
If you click Yes you will see the Create Virtual IP Address panel next. Proceed
with step 3. If not, you will see the Inbound Mail Filtering panel. Skip to step
4.
3
On the Create Virtual IP Address panel, specify the IP address and netmask
to associate with the specified port.
4
On the Inbound Mail Filtering panel, choose the IP address to use for inbound
mail.
5
If desired, change the port specification for inbound mail.
6
On the Inbound Mail Filtering - Connections panel, specify the mail servers
from which this Scanner will accept inbound mail.
You can choose All IP addresses or specify IP addresses. A typical choice
would be All IP addresses, thus allowing the appliance to accept mail from
any MTA on the Internet.
7
On the Inbound Mail Filtering - Local Relay panel, specify the internal host
to which this Scanner will relay inbound mail after filtering is complete.
You can select a host from the list or define a new host. A typical value is a
downstream mail server such as your corporate mail server.
You can also specify a port. If you check Enable MX lookup for this host, you
must specify a host name (not an IP address) for that server.
If you chose to filter only inbound mail without IM filtering, the Setup Summary
panel is displayed.
See "To review and finalize settings"
If you chose to filter inbound and outbound mail, continue completing the Add
Scanner Wizard.
See "To specify outbound mail filtering settings"
on page 44.
on page 43.
on page 43.