Setup Overview - Symantec 10521146 - Network Security 7120 User Manual

18

Setup overview

Setup overview
Figure 1-6 Bypass unit rear panel LEDs
Table 1-4 describes the LEDs shown in the diagram.
Table 1-4
Bypass unit rear panel LED descriptions
LED label LED name
LT Link test
ALM Alarm
BYP Bypass
ON Online
GIG Gigabit
You can set up the In-line Bypass unit in five basic steps.
To set up the In-line Bypass unit
1 Mount the bypass unit onto the rack.
See "Mounting onto a rack"
LED color Description
Green The LT LED glows green to indicate an active
link signal on the port.
Red The ALM LED in the top right corner of the Net
A port glows red for an alarm condition such
as lack of a link signal on one or more ports in
the port group.
Yellow The BYP LED in the top right corner of the App
A port glows yellow when the port group is
operating in bypass mode.
Green The ON LED in the top right corner of the App
B port glows green when the port group is
operating in online mode.
Green The GIG LED in the top right corner of the Net
B port glows green when the port group is
operating in gigabit mode (1000Mbps). It is off
when the port group is operating at 100 Mbps
or 10 Mbps.
on page 19.