Symantec 10547829 - Mail Security For Smtp 5.0 Smb Installation Manual page 39

5
On the Outbound Mail Filtering - Nonlocal Relay panel, specify how you want
to relay outbound mail after filtering is complete.
You can use default MX lookup, select a host from the list, or define a new
host.
You can also specify a port. If you check Enable MX lookup for this host, you
must specify a host name (not an IP address) for that server.
For outbound mail addressed to a non-local domain, there is typically no relay
host to specify. If you choose Use default MX lookup, the appliance will use
Internet MX records to deliver the mail.
6
If you chose to filter instant messages, the Configure IM interfaces panel is
displayed.
See "To specify IM settings"
If you did not choose to filter instant messages, the Setup Summary panel is
displayed.
See "To review and finalize settings"
To specify IM settings
1
On the Configure IM interfaces panel, under Internal IM Interface, choose
the Ethernet network for internal IM filtering.
2
Choose a Primary IM IP address.
The primary IM IP address is for routing internal IM traffic.
3
Choose a Secondary IM IP address.
The secondary IM IP address supports extended IM client features such as
file transfer.
Primary and Secondary IM IP addresses are required.
4 Under External IM Interface, choose the Ethernet network for external IM
filtering.
You can use the same Ethernet network as the internal IM interface or a
different one.
5
Choose an External IP address.
This IP address is for routing IM traffic to the public IM network servers.
6
The Setup Summary panel is displayed.
See "To review and finalize settings"
Setting up the Symantec Mail Security Appliance
on page 39.
on page 40.
on page 40.
How to set up the appliance
39