Symantec 10547829 - Mail Security For Smtp 5.0 Smb Installation Manual page 36

36 Setting up the Symantec Mail Security Appliance
How to set up the appliance
Note: None of the settings you specify using the wizard are final until you click
Finish at the end of the wizard. If you step through all the panels of the wizard
and do not click Finish, configuration settings will be unchanged.
To specify administrator, time, local domain, and locale settings
1
On the Administrator Settings panel, specify an email address for the
administrator.
The system sends alerts to this address if alert notifications are enabled. You
can configure additional administrators in the Control Center later.
2
On the Time Settings panel, specify your system-wide time settings.
You can specify up to three NTP servers, set the time manually, or choose
not to change the time.
3
On the Local Domains panel, add the domains for which you accept incoming
mail.
You can also add specific email addresses.
To delete a domain from the list, check it and click Delete.
4
For each domain or email address you add, optionally specify that messages
should be routed through a specific host and port.
You can optionally check Enable MX Lookup. You can also import a list of
local domains.
5
On the System Locale panel, specify the locale that the appliance should use
for formatting numbers, dates, and times, and then click Next.
Do one of the following:
If you are setting up a Control Center-only appliance, review the information
on the Setup Wizard Summary panel.
See "To review and finalize settings"
You must set up a Scanner on another appliance before you can filter mail.
See "Setting up a Scanner"
If you are setting up a Control Center and a Scanner on this appliance, continue
with the Setup Wizard.
See "To specify the Scanner role"
Note: If you plan to use one appliance as both a Control Center and a Scanner,
add the Scanner on that appliance before adding other Scanners.
on page 40.
on page 40.
on page 37.