Symantec 10547829 - Mail Security For Smtp 5.0 Smb Installation Manual page 37

To specify the Scanner role
1
On the Scanner Role panel, specify how you will use this Scanner.
You can choose to filter inbound mail, outbound mail, or both inbound and
outbound mail, and instant messaging filtering. Depending on your choice,
do the following:
If you select both inbound and outbound and you have only specified one
physical port, you will see the Create Virtual IP Address panel next. Proceed
with step 2.
If you select both inbound and outbound and you have specified two
physical ports, you will see the Create Optional Virtual IP Address panel
next. Proceed with step 2.
If the above does not apply:
If you chose to filter inbound mail, you will see the Inbound Mail
Filtering panel. Proceed with step 4.
If you chose to filter outbound mail only, you will see the Outbound
Mail Filtering panel.
See "To specify outbound mail filtering settings"
2
On the Create Optional Virtual IP Address panel, read the instructions and
click Yes or No.
If you click Yes you will see the Create Virtual IP Address panel next. Proceed
with step 3. If not, you will see the Inbound Mail Filtering panel. Skip to step
4.
3
On the Create Virtual IP Address, specify the IP address and netmask to
associate with the specified port.
4
On the Inbound Mail Filtering panel, choose the IP address to use for inbound
mail.
5
If desired, change the port specification for inbound mail.
6
On the Inbound Mail Filtering - Connections panel specify the mail servers
from which this Scanner will accept inbound mail.
You can choose All IP addresses or specify IP addresses or hostnames. A
typical choice would be All IP addresses, thus allowing the appliance to accept
mail from any MTA on the Internet.
Setting up the Symantec Mail Security Appliance
How to set up the appliance
37
on page 38.