Symantec 10547829 - Mail Security For Smtp 5.0 Smb Installation Manual page 32

32 Setting up the Symantec Mail Security Appliance
How to set up the appliance
3 Type YES if you want to use interface 2.
Otherwise, skip to step 6.
4
When prompted, type the IP address for Ethernet interface 2.
For example:
192.168.12.3
5
When prompted, type the netmask for Ethernet interface 2.
For example:
255.255.255.0
6
When prompted, type the IP address of the default gateway (default router).
Continue with To specify DNS settings
To specify DNS settings
1
Type YES to use the Internet's root DNS servers, or type NO and skip to step
3.
If you answered YES, you are asked if you also want to use your own DNS
servers.
2 Type YES to also use your own DNS servers, or type NO and follow the steps
in To specify the role of the appliance
3
When prompted, type the IP addresses of up to two DNS servers, then continue
with To specify the role of the appliance
If you plan to enable IM filtering, you will need a separate DNS for other hosts in
your network that routes IM traffic to a Scanner.
See "Configuring your DNS for IM filtering"
To specify the role of the appliance
1
When prompted, choose a role for this appliance: Control Center, Scanner or
Scanner and Control Center.
See "Before you set up your appliance"
2
If you chose Scanner only as the role for this appliance, specify when
prompted the IP address of the Control Center.
below.
below.
below.
on page 27.
on page 25.