Table of Contents
Advertisement
118 Configuring detection and response
Creating and applying protection policies
Setting policies to interfaces
Unapplying or removing policies from interfaces
To view a protection policy
1
On the Policies > Protection Policies tab, click a protection policy.
2
Click View.
3
In View Protection Policy, do one of the following:
Click Search Events to see all event types plus the Search Parameters
■
pane, which you can use to customize the event view.
Click Full Event List to see all event types.
■
Right-click an event type to view its description in your browser, or to
■
view its logging and blocking rules.
This section describes how to set protection policies to interfaces.
To set a protection policy to an interface
1
On the Policies > Protection Policies tab, click a protection policy in the left
pane.
2
Click Set to Interfaces.
3
In Apply Policy to Selected Interface, check one or more interfaces, in-line
pairs, or interface groups to apply this policy to.
4
Click OK.
5
On the Protection Policies tab, click Apply.
You can remove protection policies from interfaces in two ways. The first uses a
procedure similar to assigning policies to interfaces. The other way of
unapplying a policy starts with selecting the interface.
To remove a protection policy from an interface
1
On the Policies > Protection Policies tab, click the protection policy in the
left pane.
2
Click Set to Interfaces.
3
In Apply Policy to Selected Interface, uncheck one or more interfaces, in-
line pairs, or interface groups to remove this policy from.
4
Click OK.
5
On the Protection Policies tab, click Apply.
Advertisement
Table of Contents
Troubleshooting
