McAfee AVDCDE-AA-AA - Active Virus Defense Suite User Manual page 45

14. At this point, you can:
• Finish your installation. Leave the Scan Memory for Viruses
before Configuring checkbox clear, then click Skip Config to finish
your installation. Setup will ask if you want to start the VShield
scanner and the VirusScan Console immediately. To do so, select the
Start VirusScan checkbox, then click Finish. Your VirusScan
software is ready for use.
Š
NOTE: If you had a previous VirusScan version installed on
your computer, you must restart your system in order to start
the VShield scanner. Setup will prompt you to restart your
system.
• Choose configuration options for your installation. You can choose
to scan your system, create an emergency disk, or update your virus
definition files before you start the VShield scanner and the
VirusScan Console.
To do so, select the Scan Memory for Viruses before Configuring
checkbox to have Setup start the VirusScan application briefly to
check your system memory. Next, click Configure.
Setup will start the VirusScan application to examine your system
memory for viruses before it continues. If it finds an infection, it will alert
you and give you a chance to respond to the virus. To learn about your
options, see Chapter 3, "Removing Infections From Your System."
finds nothing, the application will flash briefly as it scans your system,
then Setup will display the first of two configuration panels
Figure 2-10. Configuration panel
Installing VirusScan Software
(Figure
User's Guide
If it
2-10).
45