Table of Contents
Advertisement
Basic Operation
Turning On CD Player
ON/STANDBY
To turn on the CD Player, press the [ ON/STANDBY]
button on the unit or the remote controller. Press the
[ ON/STANDBY] button again to set the CD Player to
Standby.
Setting Auto Standby (ASb)
ENTER
SETUP
1
You can specify that if the CD Player is left stopped for
30 minutes, the power will automatically turn off,
placing the unit in Standby mode (Auto Standby
function).
On the North American model:
The default setting is "Off".
On the European model:
The default setting is "On".
Make settings for this function while playback is
stopped.
1
Press the [SETUP] button.
2
Use the [] or [] button to display "ASb";
then press the [ENTER] button.
3
Use the [] or [] button to switch "Off" or
"On"; then press the [ENTER] button.
4
"COMPLETE" appears on the display.
If this setting is "On," the ASb indicator will be lit.
2
3
Notes:
• If an iPod/iPhone is connected, ASb will not operate
because the connected unit is being charged.
• If playback is paused, the power will remain on even
after 30 minutes have elapsed; the Auto Standby
function will not operate.
• If Auto Standby is "On," the "ASb" indicator will
blink approximately 30 seconds before Auto Standby
operation occurs.
Changing the Display Brightness
Press the remote controller's [DIMMER]
button repeatedly to select the following
options:
Normal
Using Headphones
Turn down the volume, then connect your stereo
headphones (ø 6.3 mm, 1/4 inch phone plug) to the
[PHONES] jack.
You can adjust the volume by using the [PHONES
LEVEL] knob.
PHONES
jack
DIMMER
Dim
Dimmer
En-
15
Hide quick links:
Advertisement
Table of Contents
