Default Settings; Configuring The Basic Interface Parameters - Cisco 7206 - VXR Router Configuration Manual

Default Settings

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Default Settings
Table 2-5
Table 2-5
Parameters
Description
Beacon
Debounce timer
Bandwidth
Throughput delay
Administrative status
MTU
UDLD global
UDLD per-port enable state for fiber-optic media Enabled on all Ethernet fiber-optic LAN ports
UDLD per-port enable state for copper media
UDLD message interval
UDLD aggressive mode
Carrier delay
Error disable
Error disable recovery
Error disable recovery interval
Link debounce
Port profile

Configuring the Basic Interface Parameters

When you configure an interface, you must specify the interface before you can configure its parameters.
The following sections explain how to specify the interface and configure each of its basic parameters:
•
•
•
•
•
•
•
•
•
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
2-14
lists the default settings for the basic interface parameters.
Default Basic Interface Parameter Settings
Specifying the Interfaces to Configure, page 2-15
Configuring the Description, page 2-16
Configuring the Beacon Mode, page 2-17
Changing the Bandwidth-Rate Mode, page 2-19
Configuring the Error-Disabled State, page 2-22
Configuring the MDIX Parameter, page 2-25
Configuring the Debounce Timer, page 2-26
Configuring the Interface Speed and Duplex Mode, page 2-28
Configuring the Flow Control, page 2-30
Chapter 2 Configuring Basic Interface Parameters
Default
Blank
Disabled
100 milliseconds
Data rate of interface
100 microseconds
Shutdown
1500 bytes
Globally disabled
Disabled on all Ethernet 10/100 and
1000BASE-TX LAN ports
Disabled
Disabled
2 seconds or 50 milliseconds
Disabled
Disabled
300 seconds
Enabled
Disabled
OL-23435-03