Shutting Down And Activating The Interface - Cisco 7206 - VXR Router Configuration Manual

Chapter 2 Configuring Basic Interface Parameters
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
This example shows how to configure the throughput-delay time so that one interface is preferred over
another. A lower delay value is preferred over a higher value. In this example, Ethernet 7/48 is preferred
over 7/47. The default delay for 7/48 is less than the configured value on 7/47, which is set for the highest
value (16777215):
switch# configure terminal
switch(config)# interface ethernet 7/47
switch(config-if)# delay 16777215
switch(config-if)# ip address 192.168.10.1/24
switch(config-if)# ip router eigrp 10
switch(config-if)# no shutdown
switch(config-if)# exit
switch(config)# interface ethernet 7/48
switch(config-if)# ip address 192.168.11.1/24
switch(config-if)# ip router eigrp 10
switch(config-if)# no shutdown
switch(config-if)#
Note You must first ensure the EIGRP feature is enabled by running the feature eigrp command.

Shutting Down and Activating the Interface

You can shut down and restart Ethernet or management interfaces. When you shut down interfaces, they
become disabled and all monitoring displays show them as being down. This information is
communicated to other network servers through all dynamic routing protocols. When the interfaces are
shut down, the interface is not included in any routing updates. To activate the interface, you must restart
the device.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
OL-23435-03
configure terminal
interface interface
shutdown
show interface interface
no shutdown
show interface interface
exit
copy running-config startup-config
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
Configuring the Basic Interface Parameters
2-37