Table of Contents
Advertisement
Configuring Port Channels
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
See
Note
the port-channel interface. See
configuring IPv4 and IPv6 addresses on the port-channel interface.
If you are familiar with the Cisco IOS CLI, be aware that the Cisco NX-OS commands for this feature
Note
might differ from the Cisco IOS commands that you would use.
Creating a Port Channel
You can create a port channel before you create a channel group. The software automatically creates the
associated channel group.
BEFORE YOU BEGIN
Enable LACP if you want LACP-based port channels.
Ensure that you are in the correct VDC (or use the switchto vdc command).
SUMMARY STEPS
1.
2.
3.
4.
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
6-16
Adding a Layer 3 Port to a Port Channel, page 6-19
Configuring the Bandwidth and Delay for Informational Purposes, page 6-21
Configuring a Port-Channel Description, page 6-24
Configuring Flow Control, page 6-26
Configuring Load Balancing Using Port Channels, page 6-27
Enabling LACP, page 6-29
Configuring LACP Port-Channel Port Modes, page 6-30
Configuring LACP Port-Channel MinLinks, page 6-31
Configuring the LACP Port-Channel MaxBundle, page 6-32
Configuring the LACP Fast Timer Rate, page 6-34
Configuring the LACP System Priority, page 6-34
Configuring the LACP Port Priority, page 6-35
Disabling LACP Graceful Convergence, page 6-36
Disabling LACP Suspend Individual, page 6-39
Chapter 2, "Configuring Basic Interface Parameters,"
configure terminal
interface port-channel channel-number
show port-channel summary
copy running-config startup-config
Chapter 4, "Configuring Layer 3 Interfaces,"
Chapter 6
Configuring Port Channels
for information on configuring the MTU for
for information on
OL-23435-03
- Quick Links:
- Enabling Lacp
Hide quick links:
Advertisement
Chapters
Table of Contents
