Configuring The Lacp Port-Channel Maxbundle - Cisco 7206 - VXR Router Configuration Manual

Configuring Port Channels
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
DETAILED STEPS
Command
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Step 2
interface port-channel number
Example:
switch(config)# interface port-channel 3
switch(config-if)
Step 3
lacp min-links number
Example:
switch(config-if)# lacp min-links 3
Step 4
show running-config interface
port-channel number
Example:
switch(config-if)# show running-config
interface port-channel 3
Use the no lacp min-links command to restore the default port-channel min-links configuration.
Command
no lacp min-links
Example:
switch(config)# no lacp min-links
This example shows how to configure port-channel interface min-links on module 3:
switch# configure terminal
switch (config)# lacp min-links 3

Configuring the LACP Port-Channel MaxBundle

With Cisco NX-OS Release 5.1, you can configure the LACP minlinks feature. Although minlinks and
maxbundles work only in LACP, you can enter the CLI commands for these features for non-LACP port
channels, but these commands are nonoperational.
BEFORE YOU BEGIN
Ensure that you are in the correct port-channel interface.
SUMMARY STEPS
1.
2.
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
6-32
configure terminal
interface port-channel number
Chapter 6
Purpose
Enters configuration mode.
Specifies the interface to configure, and enters the
interface configuration mode.
Specifies the port-channel interface to configure
min-links, and enters the interface configuration mode.
The default value for port-channel min-links is 1. The
allowed range is 1 to 16.
(Optional) Displays the port-channel min-links
configuration.
Purpose
Restores the default port-channel min-links
configuration.
Configuring Port Channels
OL-23435-03