Monitoring Layer 3 Interfaces - Cisco 7206 - VXR Router Configuration Manual

Monitoring Layer 3 Interfaces

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Command
show interface loopback number description
show interface loopback number status
show interface vlan number
show interface vlan number brief
show interface vlan number description
show interface vlan number private-vlan
mapping
show interface vlan number status
Monitoring Layer 3 Interfaces
Use the following commands to display Layer 3 statistics:
Command
load- interval {interval seconds {1 | 2 | 3}}
show interface ethernet slot/port counters
show interface ethernet slot/port counters brief Displays the Layer 3 interface input and output
show interface ethernet slot/port counters
detailed [all]
show interface ethernet slot/port counters
errors
show interface ethernet slot/port counters
snmp
show interface ethernet slot/port.number
counters
show interface port-channel channel-id.number
counters
show interface loopback number counters
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
4-18
Chapter 4 Configuring Layer 3 Interfaces
Purpose
Displays the loopback interface description.
Displays the loopback interface administrative
status and protocol status.
Displays the VLAN interface configuration,
status, and counters.
Displays the VLAN interface operational status.
Displays the VLAN interface description.
Displays the VLAN interface private VLAN
information.
Displays the VLAN interface administrative
status and protocol status.
Purpose
Beginning with Cisco NX-OS Release 4.2(1) for
the Cisco Nexus 7000 Series devices, sets three
different sampling intervals to bit-rate and
packet-rate statistics. The range for VLAN
network interface is 60 to 300 seconds, and the
range for Layer interfaces is 30 to 300 seconds.
Displays the Layer 3 interface statistics (unicast,
multicast, and broadcast).
counters.
Displays the Layer 3 interface statistics. You can
optionally include all 32-bit and 64-bit packet and
byte counters (including errors).
Displays the Layer 3 interface input and output
errors.
Displays the Layer 3 interface counters reported
by SNMP MIBs. You cannot clear these counters.
Displays the subinterface statistics (unicast,
multicast, and broadcast).
Displays the port-channel subinterface statistics
(unicast, multicast, and broadcast).
Displays the loopback interface input and output
counters (unicast, multicast, and broadcast).
OL-23435-03