Cisco 7206 - VXR Router Configuration Manual page 119

Chapter 4 Configuring Layer 3 Interfaces
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
DETAILED STEPS
Command
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Step 2
feature interface-vlan
Example:
switch(config)# feature interface-vlan
Step 3
interface vlan number
Example:
switch(config)# interface vlan 10
switch(config-if)#
Step 4
ip address ip-address/length
Example:
switch(config-if)# ip address
192.0.2.1/8
ipv6 address ipv6-address/length
Example:
switch(config-if)# ipv6 address
2001:0DB8::1/8
Step 5
show interface vlan number
Example:
switch(config-if)# show interface vlan
10
Step 6
copy running-config startup-config
Example:
switch(config-if)# copy running-config
startup-config
OL-23435-03
configure terminal
feature interface-vlan
interface vlan number
ip address ip-address/length
or
ipv6 address ipv6-address/length
(Optional) show interface vlan number
(Optional) copy running-config startup-config
Purpose
Enters configuration mode.
Enables VLAN interface mode.
Creates a VLAN interface. The number range is from
1 to 4094.
Configures an IP address for this VLAN interface. See
the Cisco Nexus 7000 Series NX-OS Unicast Routing
Configuration Guide, Release 5.x, for more
information on IP addresses.
Configures an IPv6 address for this VLAN interface.
See the Cisco Nexus 7000 Series NX-OS Unicast
Routing Configuration Guide, Release 5.x, for more
information on IPv6 addresses.
(Optional) Displays the Layer 3 interface statistics.
(Optional) Saves this configuration change.
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
Configuring Layer 3 Interfaces
4-11