Default Settings; Configuring Layer 3 Interfaces; Configuring A Routed Interface - Cisco 7206 - VXR Router Configuration Manual

Default Settings

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
•
•
•
If you are familiar with the Cisco IOS CLI, be aware that the Cisco NX-OS commands for this feature
Note
might differ from the Cisco IOS commands that you would use.
Default Settings
Table 4-1
Table 4-1
Parameters
Admin state

Configuring Layer 3 Interfaces

This section includes the following topics:
•
•
•
•
•
•
•

Configuring a Routed Interface

You can configure any Ethernet port as a routed interface.
BEFORE YOU BEGIN
Ensure that you are in the correct VDC (or use the switchto vdc command).
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
4-6
The Cisco Nexus 2000 Fabric Extender can not participate in a routing protocol adjacency with a
device attached to its port. Only direct route is supported. This applies to both of the supported
connectivity cases:
SVI with Fabric Extender single port or port-channel in Layer 2 mode.
–
– Fabric Extender port or port-channel in Layer 3 mode.
Layer 3 router interfaces and sub-interfaces can not be configured on an F1 I/O module.
F2-series I/O modules do not support per-VLAN statistics. Therefore, the show interface command
will not display per-VLAN Rx/Tx counters or statistics for switch virtual interfaces (SVIs).
lists the default settings for Layer 3 interface parameters.
Default Layer 3 Interface Parameters
Configuring a Routed Interface, page 4-6
Configuring a Subinterface, page 4-8
Configuring the Bandwidth on an Interface, page 4-10
Configuring a VLAN interface, page 4-10
Configuring Inband Management in the Nexus Chassis, page 4-13
Configuring a Loopback Interface, page 4-15
Assigning an Interface to a VRF, page 4-16
Chapter 4 Configuring Layer 3 Interfaces
Default
Shut
OL-23435-03