Before You Begin; Installation Requirements; Default Settings - Cisco RV315W Quick Start Manual

Welcome
Thank you for choosing the Cisco RV315W Broadband Wireless VPN
Router. The RV315W provides routing, switching, security, wireless, 3G,
Virtual Private Network (VPN), quality of service (QoS), and flow control
capabilities for small businesses.
This guide describes how to physically install your RV315W and launch
web-based Configuration Utility to configure and manage your RV315W.

Before You Begin

1

Installation Requirements

Before you begin the installation, make sure that you have the following:
• An active Internet account.
• RJ-45 Ethernet cables (Category 5E or higher) for connecting
computers, WAN and LAN interfaces, or other devices.
• PC with Microsoft Internet Explorer 6.0 (or higher) or Mozilla Firefox 3.0
(or higher) for using web-based Configuration Utility.
• (Optional) Tools for attaching the RV315W to the wall. Instructions are
provided for wall-mounting, but the wall-mounting hardware is
user-supplied.

Default Settings

These are the default settings used when configuring your RV315W for the
first time:
Parameter
Username
Password
LAN IP
DHCP Range
Press and hold the RESET button for more than 5 seconds with a
N
OTE
paper clip or a pencil tip to reboot the unit and restore the factory
defaults. Changes that you have previously made to the RV315W
settings are lost.
2
Default Value
cisco
cisco
192.168.1.1
192.168.1.100 to 192.168.1.200
Cisco RV315W Broadband Wireless VPN Router Quick Start Guide