Asus GIGAX2024 User Manual page 77

[Multicast] [Enabled/Disabled]
[Destination Lookup Failure] [Enabled/Disabled]
User can limit the broadcast, multicast, and flooding (due to destination lookup
failed) traffic rate by turning the traffic control on.
CLI command: l2 rate set <1: bcast/2: mcast/3: dlf> <enable/disable>
[Limit]
Displays the current rate limitation value of the switch. User can change this
value by giving a new limit value. This value is applied to all of the traffic control
mentioned above.
CLI command: l2 rate limit <limit rate>
[Reload]
Restores the previous saved settings from configuration file.
CLI command: l2 rate retrieve
[Aging Time]
User can set the ARL(Address Resolution Logic) entries aging time by setting
the aging time value.
CLI command: l2 arl age [aging time value]
[Query by Port]
ARL entries existed in ARL table can be queried according to port number.
CLI command: l2 arl port <port number>
[Query by VLAN ID]
ARL entries existed in ARL table can be queried according to VLAN ID.
CLI command: l2 arl vlan <vlan id>
[Query by MAC Address]
ARL entries existed in ARL table can be queried according to MAC address.
CLI command: l2 arl mac <mac address> [vlan id]
[MAC Address]
[VLAN ID]
[Port Selection]
GigaX2024/2048 L2 Managed Switch User Manual
65