Figure 49. Port Access Control - Asus GIGAX2024 User Manual

Quiet Period: If authentication failed either from RADIUS or local database,
the switch waits upon this time period before sending another authentication
request to the port user.
Retransmission Time: If the port user failed to respond to authentication
request from the switch, the switch waits upon this time period before
sending another authentication request to the port user.
Max Reauthentication Attempts: Retry count if the port user failed to
respond to authentication requests from the switch.
The second part is the port settings. Please click Modify when youʼre done with
the modifications.
Port: Specify which port to configure.
Multi-host: If enabled, ALL hosts connected to the selected port are allowed to
use the port if ONE of the hosts passed the authentication. If disabled, only ONE
host among other hosts passed the authentication is allowed to use the port.
Authentication Control: If ʻforce_authorizedʼ is selected, the selected port is
forced authorized. Thus, traffic from all hosts is allowed to pass. Otherwise, if
ʻforce_unauthorizedʼ is selected, the selected port is blocked and no traffic can
go through. If ʻAutoʼ is selected, the behavior of the selected port is controlled
by 802.1x protocol. All ports should be set to ʻAutoʼ under normal conditions.
Guest VLAN: Specify a guest VLAN to clients that are not 802.1x-capable.
Click OK to make the setting send to the switch (HTTP server). Click Reload to
refresh the settings to current value. To make the configuration effective, please
go to Save Configuration page, then click Save.
GigaX2024/2048 L2 Managed Switch User Manual

Figure 49. Port Access Control

39