Asus GIGAX2024 User Manual page 34

GigaX2024/2048 L2 Managed Switch User Manual
of the link aggregation group according to source MAC address, destination
MAC address, source and destination MAC address, source IP address,
destination IP address, or source and destination IP address.
Name: the group name. The string of group name cannot include character ʻ/ʼ
and space.
Trunk ID: a number to identify the trunk group besides the group name.
LACP: Enable/Disable LCAP on selected trunk. LACP mode is fixed to be
Active.
Remove Trunk: Remove the selected trunk.
Port Icons: these port icons are listed in a way like the front panel. You have
to click on the icon the select the group members. The port can be removed
from the group by clicking the selected port again.
Click OK to make the setting send to the switch (HTTP server). Click Reload to
refresh the settings to current value. To make the configuration effective, please
go to Save Configuration page, then click Save.
You have to check the runtime link speed and duplex mode to make sure the
trunk is physically active. Go to Physical Interface and check the link mode in
the runtime status window for the trunk ports. If all the trunk members are in the
same speed and full duplex mode, then the trunk group is set up successfully.
If one of the members is not in the same speed or full duplex mode, the trunk
is not set correctly. Check the link partner and change the settings to have the
same speed and full duplex mode for all the members of your trunk group.
Note
22
• All the ports in the link aggregation group MUST operate in
full-duplex mode at the same speed.
• All the ports in the link aggregation group MUST be
configured in auto-negotiation mode or full duplex mode. This
configuration will make the full duplex link possible. If you set
the ports in full duplex force mode, then the link partner MUST
have the same setting. Otherwise the link aggregation could
operate abnormally.
• All the ports in the link aggregation group MUST have the
same VLAN setting.
• All the ports in the link aggregation group are treated as
a single logical link. That is, if any member changes an
attribute, the others will change too. For example, a trunk
group consists of port 1 and 2. If the VLAN of port 1 changes,
the VLAN of port 2 also changes with port 1.