System Cannot Load Smartstart; Smartstart Fails During Installation - HP DL560 - ProLiant - 1 GB RAM User Manual

System Cannot Load SmartStart

Possible Cause
A SmartStart requirement is
not met.
A CD-ROM drive cable is not
connected to CD-ROM drive.
Existing software is causing
conflict.
IMPORTANT: Clearing NVRAM removes user data from the boot drives. To
clear NVRAM and erase the boot drives, select the Advanced Options menu
in RBSU, and then select Erase NVRAM/Boot Space Disk.

SmartStart Fails During Installation

Possible Cause
An error occurs during
installation.
The CMOS is not cleared.
IMPORTANT: Clearing NVRAM removes user data from the boot drives. To
clear NVRAM and erase the boot drives, select the Advanced Options menu
in RBSU, and then select Erase NVRAM/Boot Space Disk.
Server Specific Troubleshooting
Possible Solution
Check the SmartStart Release Notes provided
in the SmartStart Online Reference
Information on the SmartStart CD.
Be sure the CD-ROM drive cables are
properly connected.
Clear NVRAM and boot drives in RBSU and
reinstall the operating system.
Possible Solution
Follow the error information provided. If
necessary, clear NVRAM in RBSU and
reinstall the operating system.
Clear NVRAM in RBSU and reinstall the
operating system.
107